Electrical

Why has the inspector requested additional work be done that isn't related to the current job?

Occasionally, an inspector may find other issues when visiting your home that require attention. This is most common when improvements have been done in the past without proper inspections or permits. Depending on the type of issue, inspectors can sometimes require that other additional repairs be made before allowing the current job to pass inspection.

This can be frustrating as it may require additional work on your home and can delay current work being done.  Inspectors are most likely to make this decision when the previous work is wildly outside of code or represents a safety hazard in your home.  It doesn't happen very often but can become an unexpected issue that must be dealt with.

The best way to prevent this is to ensure that all work done to your home is properly permitted and inspected.

Back to FAQ

Will my job require a permit?

County permitting offices exist to both record improvements for tax purposes as well as oversee work being done to ensure that it is safe and meets code building code standards.  If a job is considered new service, an improvement to existing service or an upgrade it may require a permit. In general repairs to existing systems do not require permits.

The permitting process is fairly simple, a permit is applied for, a fee is collected and then an inspector visits at various stages to ensure that work is completed correctly.

The permit process can add additional time to completion as in most cases a county inspector will need to visit and approve work being done at different stages of completion. Depending on the type of work being done this can be one or multiple visits.  If the inspector has a question or finds a problem they must re-inspect the work before the job can proceed. Most inspectors require at least 24 hours to schedule another visit so this can add additional days to a job.

Back to FAQ

What is the difference between AFCI and GFCI breakers and outlets?

Both of these breaker/outlet types are designed to provide protection for you and your home.

GFCI (Ground Fault Circuit Interrupter) are designed to prevent any excess current from escaping the line and potentially shocking people by turning off the circuit when power goes where it shouldn’t, wiring becomes wet, or damaged.

These are required for many outlets located in kitchens, bathrooms, outdoors and several other locations. If there is ungrounded or leaking current, the GFCI "trips" to prevent the potential for electrical shock. The outlet is then reset with a small button located on the outlet.

GFCI have been required by code since the late 1960's so most homeowners are familiar with these outlets. They are sometimes called GFI.

AFCI (Arc Fault Circuit Interrupter) are designed to protect your home against fires caused by loose wires and other current disruptions that may allow electrical current to arc and start a fire. When these arcs are detected on the circuit, it will "trip" and cut off electricity to the circuit.

Arc faults can be caused by any number of things. Common causes for arc faults are loose wires, wires that have been damaged by nails or animals, damaged or frayed power cords or simply old wiring. Because these arcs often occur in the walls of a home they can be a huge fire risk.

Code now requires that residential areas of your home be updated with AFCI protected circuits during any remodeling or repair work. AFCI protection is available both on a circuit breaker level (inside your electrical panel) and on outlets and receptacles. These look very similar to a GFCI outlet or breaker with a small reset button that tests the current before allowing the electricity to flow again.

 

Back to FAQ

What is a generator transfer switch?

A transfer switch is a switch that moves electrical load between two different sources, normally between a generator and an electrical panel/utility line.

Transfer switches can be automatic (ATS) (common with standby generators) or manual which require you to physically move the switch when you want to redirect the source of electricity. Both types ensure that power is not backfed to the generator or utility line when changing back and forth.

There are many options available and correct selection will depend on your specific home's needs.

Back to Generator FAQ

Back to FAQ